(AI KB) Bullhorn RM510S/C : Quick Facts (Power, Battery, Signal, Firmware, Dome Swap)

Short answers to common questions about RM510 units.

Connecting:

  1. You connect to the I/O Module over Bluetooth through the Bullhorn FieldPro Application and can stay connected within about 15 feet.
  2. Swipe a magnet along the side of the I/O Module to turn on Bluetooth for the unit. An arrow next to the DC input of the I/O shows where to swipe. 

Power and Battery:

  1. Normal DC Input Voltage for an RM5 unit is 10 to 14 V. The RM5 reports this at the radio and is visible within Bullhorn FieldPro, it can also be confirmed through the Red/Red-white wires on the black terminal block.
  2. System bus voltage on the Readings screen: 
    • 17 to 23 V is Good.
    • 15 V is OK but not ideal.
    • 14 V is Bad and means it is not recognizing power from the rectifier to the I/O.
  3. A fully charged backup battery lasts up to two hours after input power is lost, depending on the frequency of the reporting schedule.
  4. A critically low battery needs 2 to 12 hours of charging before the unit can send again.
  5. If the backup battery is not seated the right way round in the dome, the unit will not power on.
  6. To see battery status:
    • Bullhorn FieldPro - Open the Options menu and tap Readings
    • Bullhorn Web - Select the unit, it is viewable under Current Data and Unit Health.

Signal:

  1. Unit Overview in Bullhorn FieldPro will show a Signal Quality ranging from Normal to Poor.
    • Satellite units show signal (RSSI) from 0 to 5. Higher is better. The unit needs 1 or above to send commands. The lower, the slower the response time.
    • Cellular units show a negative number (RSRP) from 0Db to -120Db.
      • -100 to -119 Db may transmit but can be inconsistent with the unit responding.
      • -61Db to -99Db is the Best range for connection.
      • -60Db or below indicates a connection issue.
  2. Signal updates every 120 seconds. Refresh the screen to see the new value.

Firmware:

  1. American Innovations recommends the latest firmware. Bullhorn FieldPro prompts you to update when the unit is out of date.
  2. Firmware cannot be updated from Bullhorn Web on satellite units. Update on-site over Bluetooth with Bullhorn FieldPro.
  3. Once the file is loaded from Bullhorn FieldPro, the update finishes on its own once disconnected. The blue LED blinks slowly while updating. This process can take 20-30 minutes.

Changing an RM510 Cell to Satellite:

  1. The RM510C (cellular) and RM510S (satellite) domes can be swapped. You do not need a whole new unit.
  2. The new dome needs its own service plan.
  3. After the swap, Bullhorn Web must be synced so it shows the new dome and its serial number. Submit a support request for the plan and the sync.

Good to know:

Make sure you follow your company safety checklist before opening a dome or working at the rectifier.

When to contact support:

  • The unit has correct input power and still shows a critical battery after 12 hours.
  • Signal stays at 2 or below connection on a satellite unit with a clear view of the sky.
  • A firmware update does not finish.

Was This Article Helpful?

0 out of 0 found this helpful