Use this article to send a Read on Demand or Stop Interruption, to see if a command reached the unit, or to cancel a command or a scheduled interruption.

Steps (Read on Demand & Stop Interruption):

  1. Hover over Units and select All Units.
  2. Select Commands
  3. While the Commands pane is open
    1. Choose Read on Demand or Stop Interruption.
    2. Select the unit or units.

Read on Demand returns the analog readings and a health check. 
Stop Interruption stops any interruption program that is running.

Steps (Command Verification):

  1. Hover over Units and select Send Commands.
  2. Click refresh to load the latest information.
  3. On the Schedule tab, read the Status and Completion columns for your command.
  4. For older commands, open the History tab. You can filter by unit, unit type, status or date.

Steps (Cancel Commands):

This is only available for RM4 Series Units, Contact Support for RM5 Series or wait for the unit to reattempt (It will attempt up to 5 times)

  1. Select the unit you want to cancel a command for
  2. Click the Outgoing Packets tab
  3. To cancel, click the X on the right side of the command. (This option is not available for RM5 Units)

Steps (Cancel or Adjust Interruption):

  1. Select the unit you want to cancel or change interruption
  2. Click the Outgoing Packets tab
  3. To cancel, click the X on the right side of the command. (This option is not available for RM5 Units)
  4. To change the Interruption after cancelled:
    1.  Return to the All Units page and select Interruption 
      1. Change the interruption mode
      2. Change the Start/Stop Date and Time (Ensure Time Zone is correct)
      3. Change the ON/OFF Cycle and Synchronize (Starting in OFF or ON)
      4. Check the Units you're wanting to interrupt on the main panel
      5. Click Send on the Interruption Panel
    2. Select the unit and Settings on the Unit Detail pane
      1. Click the (+) to for RM5 Series and select Interruption
        1. Change the Interruption Mode
        2. Ensure Time Zone is correct
        3. Set Synchronize Settings (Starting in OFF or ON)
        4. Change the Start/Stop Date and Time
        5. Change the ON/OFF Cycle Times
        6. Click Save
      2. Settings for RM4 Series
        1. Ensure Time Zone is correct
        2. Set Synchronize Settings (Starting in OFF or ON)
        3. Change the Interruption Mode
        4. Change the Start/Stop Date and Time
        5. Change the ON/OFF Cycle Times
        6. Click Save
        7. Select Send Settings on the Left Side
        8. Click Sync Unit Settings

Good to know:

  • When a unit does not acknowledge a command or settings, Bullhorn Web emails the person who sent it. The email has a link to Resend, or to Revert settings to the last ones that worked.
  • A command may not be received because of network issues, unit configuration problems, or because the unit is turned off.
  • Commands to RM4150 and RM4151 units are sent immediately and cannot be canceled. 
  • To see which units are interrupting, open All Units and tick an interruption status in the Status Filter pane, for example Cathodic Protection Off, then click Apply.

When to contact support:

  • A command still fails after a resend and the unit is reporting normally.
  • A command is preventing additional communication on an RM5 Series Unit
  • A unit keeps showing an interruption or Cathodic Protection Off status after you sent Stop Interruption and the unit has reported in again.

Was This Article Helpful?

0 out of 0 found this helpful